sudomod

Posted: **Sun Apr 15, 2018 5:36 pm**

UPDATE: Fixed the wiring diagram for v2.1 board. Instead of connecting the PWM0 to pin12(GPIO18), it was connected to pin14(GND).

http://www.tinkerboy.xyz/wiring-guide-f ... ller-v2-1/

Posted: **Mon Apr 16, 2018 1:16 am**

Just purchased the v2.1 , looking forward to receiving

Posted: **Wed Apr 18, 2018 7:49 pm**

Purchased a v2.1 last night! Really looking forward to putting it to use!

Posted: **Wed Apr 18, 2018 8:22 pm**

I will be shipping all pending orders later today.

Posted: **Thu Apr 19, 2018 12:25 pm**

Just purchased a 2.0 board this morning!

Posted: **Sat May 12, 2018 3:58 am**

Update: v2.1 board upgraded to v2.2 to support 6-button arcade style buttons.

http://www.tinkerboy.xyz/product/game-b ... audio-amp/

Posted: **Sat May 12, 2018 7:50 am**

If this all-in-one board doesn't have a ribbon cable port, then how do you connect a screen to it?

Posted: **Mon May 14, 2018 1:17 am**

Gizard wrote: ↑
Sat May 12, 2018 7:50 am
If this all-in-one board doesn't have a ribbon cable port, then how do you connect a screen to it?

The GearBest 3.5" screen comes with a driver board which can be directly connected to a pi via the composite pins.

Posted: **Mon May 14, 2018 1:27 am**

Posted: **Fri May 18, 2018 8:40 pm**

On the Tinkerboy 2.1 board, could you label where the soldering points for the control buttons are located (XYAB Start Select, Up Down Left Right).

[FOR SALE] tinkerBOY's Game Boy Controller v2.0 and v2.2