You will not manage to fit a usb dongle there as it is simply too tight, what I would suggest is soldering a female usb to the test pads on the rear of the pi before soldering the pi down and locating that somewhere in the case where it won't cause the shell to not fit well. Should work out fine this way.pozooo wrote: ↑Fri Feb 22, 2019 12:06 amI really like you guys being open and honest about problems in the supply chain. I have had a good experience about your support over here. But being too optimistic and not considering problems to date and possible other delays is another thing. I know you are trying to catch up from the other end and this is only about those boards. What i really would love is the timeline being updated on a go as you get more information about those shipments from MakerFabs. This would provide more information as a whole, rather than us whining the same thing here over and over. We are just anxious to get these in our hands as the promised date is in our hands.
One question about the build. Do you think i can squeeze a wireless kb dongle between rpi usb and the charging board?
I have a nano adapter and dongle. Got a fun idea what to do with the gameboy when it's done and don't want to do many changes to it as keeping it clean build.
Hope it works out well, let us know the result,