sudomod

sandog wrote: ↑

Mon Jun 03, 2019 9:25 pm

What would cause white screen after Picicle logo during bootup.. will just stay on white screen

Reflash the image again? Is the pi booting properly? You see the green status LED on the pi? Did it work before, and then suddenly stopped?

Either way, I would reflash the image first.

sandog wrote: ↑

Mon Jun 03, 2019 9:25 pm

What would cause white screen after Picicle logo during bootup.. will just stay on white screen

What is your SDcard size?
During the first boot we happen repartition the SD card. If the SDcard is large, it may take some time. You need to wait for the system to reboot. The following system loads are fast.

I have tried 2 sd cards 16gb (used) and a 128gb (new) both sandisk. First boot up after flash they will both load up to the retro main screen . But once they r rebooted will get to picicle screen and then white screen.

sandog wrote: ↑

Tue Jun 04, 2019 3:12 pm

I have tried to sd cards 16gb (used) and a 128gb (new) both sandisk. First boot up after flash they will both load up to the retro main screen . But once they r rebooted will get to picicle screen and then white screen.

Do you use the latest version of the Picicle.img? After the appearance of the white screen, the green LED on the Raspberry is on? Can I see a video of load process?
Also check the solder pins 15 and 17 of Raspberry and resistor 10K.

Having nothing but issues :/ Screen isn't coming on at all

Edit: The screen turns on at startup (Backlight nothing else) then goes off a few seconds later

It seems everything drops out at this point

xaphor wrote: ↑

Thu Jun 06, 2019 1:28 pm

Having nothing but issues :/ Screen isn't coming on at all

Edit: The screen turns on at startup (Backlight nothing else) then goes off a few seconds later

It seems everything drops out at this point

See my previous post. Check the solder pins 15 and 17 of Raspberry and resistor 10K. The voltage on pin 15 should be about 2,7V.

PS The most common problem faced by Picicle assemblers is poor soldering of Raspberry contacts. Please check the connection before turning on the console, as described in the instructions.

Resoldered them pins and I'm still having issues with having a white screen,

xaphor wrote: ↑

Fri Jun 07, 2019 2:06 pm

Resoldered them pins and I'm still having issues with having a white screen,

Did you confirm continuity on all screen related gpios? Check the guide for the ones screen related.

And you are using his picicle image?

What can I do/check for no audio? Everything else works fine. Just no audio. Already tried a different speaker. Still no audio.

I have also checked continuity on all marked pins from the instruction manual. Good there.