[WANTED]Button pcb

[VeteranGamer]

Well as I said I was dumb and went to throw it out and I always break any electronics before I throw them out.

well thats beyond repair.....

also not thats its any consolation,
the board didn't actually look that bad before you decided to break it into pieces, most of the points were in tact and easily you could have just used jumper cable for the points that didnt work ....


good luck in trying to source another one....

maybe its a lesson to learned, dont trash or break things up.... especially when you've paid money for them (even if you haven't paid anything for it) because things like this can be salvage (especially in the condition it was in before you trashed it)

[Helder]

I have 1 older red board I can sell you that doesn't have the fancy silk screen, if you want it I can hook you up but it will be harder to test solder points without the test pads.

[VeteranGamer]

I have 1 older red board I can sell you that doesn't have the fancy silk screen, if you want it I can hook you up but it will be harder to test solder points without the test pads.

great offer
(he should snap it up, asap) if others get wind of this, you may get flooded with offers


not trying to be a downer....
but its slightly concerning, that most of the points that look toast are ones that arent even used....




hopefully lessons have been learned (fingers crossed)

[Zmoneyrecords]

Yea I know as soon as I realized how stupid I was to throw it out I regretted it. I knew I could've ran wires too but I was just being stupid an lazy and figured I would start on a new one. And I realized most of them weren't even going to be used after I broke it and I knew I was an idiot. That's part of the reason I didn't really want to show pictures because I was embarrassed that I didn't even think before I broke it.
I'll definitely buy that board from you Helder. I appreciate the offer and the help

[VeteranGamer]

Yea I know as soon as I realized how stupid I was to throw it out I regretted it. I knew I could've ran wires too but I was just being stupid an lazy and figured I would start on a new one. And I realized most of them weren't even going to be used after I broke it and I knew I was an idiot. That's part of the reason I didn't really want to show pictures because I was embarrassed that I didn't even think before I broke it.
I'll definitely buy that board from you Helder. I appreciate the offer and the help

PM him, dont let it get snapped up by someone else....


it might seem embarrassing, but the community here is very helpful and forgiving (its all about win or learn... no fails)

just be sure to take the next one a little easy, as Helder has stated its a slightly harder (but not that difficult) board to work with as it has less test points....

anything your unsure about (or you think you might have messed up) post it and i'm sure someone can help....

[Zmoneyrecords]

Thanks a lot and good call I'll pm him now.