Re: [Gauging Interest] HoolyHoo 6 Button SAIO Bracket
Posted: Tue Oct 03, 2017 7:26 am
So I received mild interest on this but I did manage to print a working model. Now I don't have a new version of Kite's board but I did obtain a DXF that lined up the holes of his design. Remember, the contact pads on Kites board have tolerances. So as long as you use the drill guide I provide to make the holes line up with the bracket rather than using the drill mark on Kites board, you should be fine. With the six button you will need to remove an extra peg in the case because it sits were a button would be but its not a big deal. Here is an image of the model:
I will put it up on my sale thread for those who want it.
Thanks
I will put it up on my sale thread for those who want it.
Thanks