sudomod

xfx9500 wrote: ↑

Sun Jun 03, 2018 11:50 am

i made on of your awesome boards myself
but when i power it up with your image is the screen upside down

It's in the Wiki

thank you now it works fine

Hi great job on this. A question and a comment - what is the best way to reach you? It seems like you have a presence at many places (Github, YouTube, Facebook, here, etc) but I don't know what your preferred communication method is. I don't want to message you here, but you may never login to check. I have a question about your battery recommendation. Since different manufacturers make 2000mAh batteries and Adafruit's stock levels change, can you post the maximum dimensions of a battery that will comfortably fit in the Gameboy cartridge shell, in mm? Thanks.

Second, the link to the BOM in the original post should be updated to: https://github.com/GameboyZero/GabozePo ... Pociao.csv

i flashed your latest image from the wiki site but the buttons are not working
how can i fix this ?

xfx9500 wrote: ↑

Sun Jun 10, 2018 6:02 am

i flashed your latest image from the wiki site but the buttons are not working
how can i fix this ?

Re flash it again? ensure the button pads are making good contact, and check that all the pi gpio connections are soldered good. It should just work.

i flash the mintyPi image for exempel the buttons are working :O
when i flash the Gaboze Pocaio uncompressed image none of the buttons working

and i test my pcb half an hour and i found no solder mistakes

xfx9500 wrote: ↑

Tue Jun 12, 2018 9:01 am

i flash the mintyPi image for exempel the buttons are working :O
when i flash the Gaboze Pocaio uncompressed image none of the buttons working

and i test my pcb half an hour and i found no solder mistakes

Any pics?
It's hard to remedy without visual

It appears from a number of screenshots that the 2.4" screen is smaller that the GB Pockets viewing area. Is it possible use a 2.8" screen and fill the viewable area and will a 2.8" screen fit the GB Pocket? Any recommendations on what 2.8" screen can be swapped onto the Gaboze Pocaio?

jeff

Hi

Does anyone have the pin out for this board?

My A button isn't working so trying to find out which pin I need to check to see if my soldering is correct.

I'm also thinking of adding some buttons to the back of the case so could do with the pins assigned to R1/L1 aswell.

Thanks