GBZ custom 3d parts. Pi3, volume knob, USB.

If you'd like to gauge interest in an idea before putting it into production, do it here!
Post Reply
Posts: 22
Joined: Wed Jan 25, 2017 2:52 pm
Has thanked: 2 times
Been thanked: 13 times

GBZ custom 3d parts. Pi3, volume knob, USB.

Post by Kalei808 » Sat Nov 10, 2018 9:39 am

I haven't been on the forums in a long time but I have built over 30 gbz to date. I have created 3d parts that fit the helder aio and possibly other button pcb boards. It makes a much cleaner install and allows the pi0w to be removed easily later if need be. Has rear screw posts. USB and volume knob mounts. You will still need to use some hot glue but a lot less. Just wanting to see if there's any interest in these parts.
Screenshot_20181110-085027.jpg (731.83 KiB) Viewed 1493 times
Screenshot_20181110-085114.jpg (945.56 KiB) Viewed 1493 times
Screenshot_20181110-085148.jpg (693.6 KiB) Viewed 1493 times
Screenshot_20181110-085515.jpg (819.7 KiB) Viewed 1493 times
Screenshot_20181110-085103__01.jpg (294.7 KiB) Viewed 1493 times
Screenshot_20181110-085424__01.jpg (154.34 KiB) Viewed 1493 times
Screenshot_20181110-085444__01.jpg (173 KiB) Viewed 1493 times

Posts: 29
Joined: Wed Sep 04, 2019 12:08 pm
Has thanked: 3 times
Been thanked: 5 times

Re: GBZ custom 3d parts. Pi3, volume knob, USB.

Post by superman » Wed Nov 13, 2019 1:04 pm

I know no one has commented but i was wondering are you making these. If not could you share the stl it would be so helpful.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest