hello guys,
i am having problems with my display in my gameboy zero.
i have a pi3 project, and i have connected the way that wemy has donne in the original guide and connected to the pp24 for the video output the ground video to the pp6 and the alimentation to the powerboost. i have the problem that when i turn on the pi, the screen is all white, and not showing any changes, when i use the hdmi output i can see that the boot is perfectly fine. i have no idea what could it be....
someone had any problem like this ? it is the same screen from adafruit that wermy used....
problem with display [white screen]
-
- Posts: 50
- Joined: Wed May 11, 2016 8:20 am
- Has thanked: 14 times
- Been thanked: 7 times
-
- Posts: 392
- Joined: Thu Jun 09, 2016 4:17 am
- Location: uk
- Has thanked: 76 times
- Been thanked: 51 times
Re: problem with display [white screen]
Check your ribbon cable is pushed right in and right way around.
Check out my modding and repair channel of retro and modern consoles:
https://www.youtube.com/channel/UCFz7yW ... GtQ/videos
https://www.youtube.com/channel/UCFz7yW ... GtQ/videos
-
- Posts: 50
- Joined: Wed May 11, 2016 8:20 am
- Has thanked: 14 times
- Been thanked: 7 times
Re: problem with display [white screen]
video connected to PP24,
two grds to PP6 and the other ground to the ground in the powerboost and the 5v to the powerboost too. and the ribbon is well connected
two grds to PP6 and the other ground to the ground in the powerboost and the 5v to the powerboost too. and the ribbon is well connected

Who is online
Users browsing this forum: No registered users and 1 guest