Problem Part 2

[Hubson]

Hello,

i am from Germany so sorry for my bad english.
I just finished part 2. Now i wont to check my controls by testing them with a n64 emulator. I had already checked the conections with a voltmeter after soldering them. So i want to setup the controls in the menu of the emulator und now i am getting a dialog a message: Sorry the input selection made is already in use...but only for some buttons not for all some work fine... is my solder work bad or how could i figure out what the problem is? again sorry for my bad english, hope somebody could help me

best wishes

Hubson

[Hubson]

Hello again,

i think i found the problem...the wire in soldered to the teensy were too long, there was conections between them on the backsite from the teensy...i think that caused the problem...only down button is not working...but my voltmeter has a connection but the editor shows nothing by pushing the down button....