help me with my screen for GBZ build

king · Post by **king** » Thu Jul 06, 2017 4:37 pm

I am trying to put the "example code" into the pi directly since i dont have wifi on the pi and I cant do the # symbol. When i press shift + 3, i get a pound symbol instead. Is there a way to change this? or do i not need to imput the # symbols when copying the code. thanks ^^

Hex · Post by **Hex** » Thu Jul 06, 2017 8:05 pm

@rodocop Both micro usb sockets have power lines connected so you can use any of them to supply power.

@king I checked some of your images and you have connected the red wire to 3.3v and not 5v. Please post recent pics with display board after you have soldered. I had the same screen and it worked nicely.

king · Post by **king** » Fri Jul 07, 2017 9:34 am

IT WORKS

thanks everyone for your help

rodocop · Post by **rodocop** » Fri Jul 07, 2017 4:08 pm

king wrote: ↑
Fri Jul 07, 2017 9:34 am
IT WORKS
thanks everyone for your help

Awesome. What did you do to get it to start working? Sure beats buying a new screen.

king · Post by **king** » Sat Jul 08, 2017 8:15 am

i set is as you told me
and did the configurations to make it recognize the smaller screen

help me with my screen for GBZ build

Re: help me with my screen for GBZ build

Re: help me with my screen for GBZ build

Re: help me with my screen for GBZ build

Re: help me with my screen for GBZ build

Re: help me with my screen for GBZ build

Who is online