Page 1 of 1
Helder's AIO 2.2 PWM1 pad broke off
Posted: Sun Mar 05, 2017 6:14 pm
by tsmed06
While putting solder on the PWM1 pad, the pad come off. Apparently I turned my soldering iron up without realizing it. The question is, am I SOL on this or is there a work around?
Re: Helder's AIO 2.2 PWM1 pad broke off
Posted: Tue Mar 07, 2017 6:14 pm
by Lphillimore
Should be able to fix this. I did the same on 2 of the volume potentiometer pads.
@helder sent me the below with the audio traces so I just followed them and soldered directly to the relevant components.
Same would apply to PWM pads see below:
- 20170208_123042.png (408.9 KiB) Viewed 2662 times