sudomod

Looking for some guidance or advice.

Built my GBZ using Wermys guide but i seem to be getting really loud static noise through my speaker. Using the adafruit 2.5 mono amp with the filter suggested in the guide.

Tried tweaking the pot on the amp without any success of making it better.

Anybody got any suggestions?

Got any pictures of the wiring etc?

89krisd wrote:Looking for some guidance or advice.

Built my GBZ using Wermys guide but i seem to be getting really loud static noise through my speaker. Using the adafruit 2.5 mono amp with the filter suggested in the guide.

Tried tweaking the pot on the amp without any success of making it better.

Anybody got any suggestions?

Also the most important part did you edit the config.txt to allow PWM audio to work?

Sorry for the overdue reply. Not been able to get any pics been busy with work.

@Helder could you point me in the direction of some form of guide showing me how to do this please?

Thanks to both of use for the replies

89krisd wrote:Sorry for the overdue reply. Not been able to get any pics been busy with work.

@Helder could you point me in the direction of some form of guide showing me how to do this please?

Thanks to both of use for the replies

So since you're asking it seems like this is your problem. Go to my support thread the info is there at the end of the first post. You can also look into the guides section for PWM Audio, simply take the SD card and put it into a PC and you will see there are a few files including the config.txt which is what you will need to edit.

@Helder Cheers mate your a legend