Raspberry Pi Zero Positioning Issue

[dcex1]

Hi All!

Just a quick one, couldn't fine if anyone has already asked this but basically I've come to the half way point in my build where I'm positioning the pi zero to have its mini hdmi port sit nicely for the open slot on the case. However because of the display board it's making it a very tight fit, so when closing it, the board and pi are crammed to each other with only some tape separating them... so my question is, is this sensible (i.e. is it going to overheat or easily cause issues)?

Thank you!

[jostie94]

take a look at this thread:http://www.sudomod.com/forum/viewtopic.php?f=8&t=2756