Page 1 of 1
Adafruit screen + kb common ground pcb?
Posted: Mon May 23, 2016 5:36 am
by 401Gaming
Ok so I'm looking into using the Kitsch bent common ground pcb for my buttons to make things a little neater and easier. My question is, will the X and y button locations on this pcb (rev. 1) get in the way of the bottom of the screen? Or are they still low enough to clear it
Re: Adafruit screen + kb common ground pcb?
Posted: Mon May 23, 2016 7:35 am
by Robots86
You should be fine even if the screen was low ive found the pcb sits just above it. Im using a car tft rather than the adafruit though....
Re: Adafruit screen + kb common ground pcb?
Posted: Mon May 23, 2016 9:39 pm
by Synnth3t1k
401Gaming wrote:Ok so I'm looking into using the Kitsch bent common ground pcb for my buttons to make things a little neater and easier. My question is, will the X and y button locations on this pcb (rev. 1) get in the way of the bottom of the screen? Or are they still low enough to clear it
I got the pcb from Kitsch-Bent. It will work perfectly fine. I sized it up with the pcb that I cut, then fried with my iron and it was a little bit shorter.