sudomod

I have a question concerning the composite solder holes on the PI Zero W.

I have mostly been following Wermy's guide and he uses a PI Zero. The composite video goes in the hole closest to the "TV" marking which is the solder hole towards the SD side of the board and is square in shape....

I have a PI Zero W and the "TV" marking is opposite and by the hole towards the ribbon cable side of the board but is round in shape....

My question is are the holes truly reversed or did they just move the marking? Which pin on the PI Zero W is composite video out and which is the ground?

Thank you for the time.....

I think they just changed the markings and not the pins.

I think theyre both composite video out's