Page 1 of 1
Connecting Teensy to PiZ
Posted: Mon Jun 06, 2016 11:55 am
by LoafSlice
where am I drawing a blank on connecting the PiZ to the Teensy?
Right now I have
Screen Board -> PiZ
PCB Button Board -> Teensy
Re: Connecting Teensy to PiZ
Posted: Mon Jun 06, 2016 11:57 am
by LoafSlice
This is what I have currently
Re: Connecting Teensy to PiZ
Posted: Mon Jun 06, 2016 1:32 pm
by Helder
Aren't you supposed to connect them vias USB?
Re: Connecting Teensy to PiZ
Posted: Mon Jun 06, 2016 3:29 pm
by DirtyBullets
after you have programmed the teensy you need to add 4 wires under the teensy connector to the pi usb (pads under the OTG connector) and wire the 5v from the pi or from a power supply (power board)
have a look in the show-off area or the guides, (or just check my first gameboy mod in my sig)