sudomod

Hi guys

Just got the screen from ePathChina, (https://www.amazon.co.uk/gp/product/B00 ... UTF8&psc=1) and the IC in it is different from all if found so far in this forum. Im new to this, so i'd apreciate if some of the mosre experienced around here could point me in the right direction to transform this in a 5v ic. I know so far that it's a 12v, one of the wire holes says it.

[img][/img].

(I can post more info/more detailed photo if necessary, please just say what is necessary to get your help in this)

as you can see is different from this one http://s20.postimg.org/prif6tlgd/Fleder_board_1.jpg

I just got the 2 tutorial sucessfully finished, I'm enjoying very much this experience so far. thanks to wermy that pushed me into this eletronics world!

Hi it's too hard to tell from the picture but maybe you can read the partnr from the two 8 pin IC's and google the pinout to see what pin is the 5v output and connect your 5v to that pin. I would verify first with a multimeter that you see 5V on that pin when the 12V is connected.

thanks sander, for the reply.

i'll check that out tonight, althought i'm far from knowing what i'm doing

cheers!

i've found that one of the chips is this one

http://www.datasheetlib.com/datasheet/1 ... 9_ame.html

I think is this one, no?

is it safe to remove?

then, can you confirm what are the steps? i'll have to connect the 3rd pin to the 12v wire, is that correct?

Here's a better photo of the board