sudomod

Here is some information that may help someone. The screw measurements for the gameboy to close the case are as follows:
Screw length: 1/4"
Screw diameter: 1/24"
Head diameter: 1/8"
Threads per inch: 42

One thing I have noticed is that the little plastic facets holding the screw in place are starting to wear out on one side of my case. I am thinking about fixing it with a very very small washer that I would glue to the top of the facet. I can report back but it may help others if they experience the same ware and tear as I did.

Might be worth reposting in the 3D printing forum to have that information on hand (or at least getting [mention]wermy[/mention]'s attention) since they're making a printable bracket.