sudomod

So for my build I bought a cheap SNES offbrand controller off of amazon. like 5$ or something and i was looking at the PCB and it looks really simple.

I having no knowledge on how this stuff is made or works was wondering how come it wouldn't be that simple when it comes to the custom stuff people are selling on these forums?

I guess I'm just wondering if any of the PCB makers have thought about a way to make a PCB that doesn't require a Teensy like device.

Sorry for my ignorance on this subject. But any answers or feedback would be awesome.

Already ahead of you :

http://www.sudomod.com/forum/viewtopic. ... =130#p5763

With that will you just be able to take a usb cable and wire it up to that PCB?

I know in the past you could buy one of those and then hook that up to a teensy or GPIO but not have a board that you can solder a USB cable to.

That board has the built in atmega which will be programmed with a USB Controller logic like those $5 SNES USB Controllers and it also incorporates a hole template as well as an PWM low pass audio filter and audio amp for a speaker.

You basically plug a usb cable or wire the connections to the Pi Zero and that's about it minus the audio wires.