Page 1 of 1
Where does this 3d hoolyhoo part go?
Posted: Sun Nov 04, 2018 5:22 pm
by Slimpreaper
Sorry wasnt exactly sure where to post this.
Does anyone know where this hoolyhoo 3d printed part goes?
I bought the following 3d parts from him
Screen bracket (6 button)
Fan vent
Power switch support
Thanks for your help
Re: Where does this 3d hoolyhoo part go?
Posted: Mon Nov 05, 2018 12:46 am
by Deen
Looks like Erics back bracket, I think.
Re: Where does this 3d hoolyhoo part go?
Posted: Mon Nov 05, 2018 1:40 am
by Hellweaver666
Deen wrote: ↑Mon Nov 05, 2018 12:46 am
Looks like Erics back bracket, I think.
Nah, I just printed one of those... it's more egg shaped (unless it's changed!).
Re: Where does this 3d hoolyhoo part go?
Posted: Mon Nov 05, 2018 6:00 am
by HoolyHoo
Slimpreaper wrote: ↑Sun Nov 04, 2018 5:22 pm
Sorry wasnt exactly sure where to post this.
Does anyone know where this hoolyhoo 3d printed part goes?
I bought the following 3d parts from him
Screen bracket (6 button)
Fan vent
Power switch support
Thanks for your help
It is used to secure the CM3 Fan cart to the case. If you have the fan cart slid in the shell, looking at it from the top, that piece goes from the right post of the cart to the existing screw hole mount on the shell. It bridges to hold the cart in place. The left side of the cart is held as well with the opposite post of the cart to the power mode tab. Maybe this image will help to visualize it.
- FanCart.png (265.58 KiB) Viewed 5031 times
Re: Where does this 3d hoolyhoo part go?
Posted: Mon Nov 05, 2018 10:05 pm
by Slimpreaper
Perfect thanks!