Page 1 of 1
question for thoe using the kitsch-bent cartridge
Posted: Sun Jun 26, 2016 9:50 pm
by chibilaharl
Hi so i am a bit confused as to the pinout and which items go where.
is this correct?
VCC-pp8
dat2-pp18
cs- pp19
data_in -pp22
sclk-pp14
Data_out-pp23
dat1-pp17
GND- to any ground or pp6?
This doesnt seem to match up with wermy's. i dont use pp15,or 17, and i seem to have pp22 and 23 that wermy doesnt use.
Re: question for thoe using the kitsch-bent cartridge
Posted: Mon Jun 27, 2016 1:56 pm
by chibilaharl
any ? im desperate
Re: question for thoe using the kitsch-bent cartridge
Posted: Mon Jun 27, 2016 2:25 pm
by jermzz
I'm having the same problem. I dunno much about SD pins. I had it the same way you do, and the pi wouldn't even turn on. As soon as I put the card in the pi itself, it booted right up into retro pi.
Kb's pins seem different. Either way, seems the way you have it up there (the way I did it too) doesn't work for me. Maybe I should try the other pins that wermy uses.
Re: question for thoe using the kitsch-bent cartridge
Posted: Wed Jun 29, 2016 8:59 pm
by Kalen
No resolve on this? I'm planning on using the same SD cartridge
Re: question for thoe using the kitsch-bent cartridge
Posted: Wed Jun 29, 2016 9:33 pm
by gnarlynick
Based off this chart I was able to mock up a quick and dirty guide. I haven't been able to test it as I was having trouble getting the SD socket soldered to the board so give it a shot and let me know. I do know PP22 & PP23 are Data + & - for the USB interface, that should be used for the USB hub/Teensy. All SD pads are on the one side of the board.
- MSDPinouts.jpg (187.59 KiB) Viewed 7364 times
[spoiler="Guide"]
- kk_gb_zero_hookup.jpg (249.87 KiB) Viewed 7364 times
[/spoiler]
Re: question for thoe using the kitsch-bent cartridge
Posted: Mon Jul 11, 2016 11:19 pm
by hueblo
Unnecessary but I can confirm the guide is correct.