Page 1 of 1
Teensy 2.0 vs Teensy LC?
Posted: Sat Jul 02, 2016 12:00 pm
by Clearmoon247
I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.
Has anyone tried using a 2.0 in place of the LC?
Re: Teensy 2.0 vs Teensy LC?
Posted: Sat Jul 02, 2016 12:04 pm
by wermy
Clearmoon247 wrote:I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.
Has anyone tried using a 2.0 in place of the LC?
Yep, Teensy 2.0 should work but I think it's a fair amount more than the LC (and the LC is even expensive for a little Arduino board tbh, it's just what I had on hand). Check out the wiki for some cheap alternatives!
sudomod.com/wiki
Re: Teensy 2.0 vs Teensy LC?
Posted: Tue Jul 05, 2016 3:32 am
by Zeryu
Clearmoon247 wrote:I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.
Has anyone tried using a 2.0 in place of the LC?
Hey ,
I used the Teensy 2.0 and it works just fine with Wermy's code.
Cheers
Re: Teensy 2.0 vs Teensy LC?
Posted: Wed Aug 31, 2016 12:21 pm
by cvp
Zeryu wrote:Clearmoon247 wrote:I currently have a teensy 2.0 available and was trying to figure out if it could work in place of the LC.
Has anyone tried using a 2.0 in place of the LC?
Hey ,
I used the Teensy 2.0 and it works just fine with Wermy's code.
Cheers
and can i solder the wire in same place? or will it use different places? And you don't overwrite the config with different parameters ?