Hello everyone!
I finished my first gameboy zero last week and I already started to order parts for an upgraded version. I would like to reuse parts from my first build like the safe shutdown switch along with the Adafruit powerbooster. I am planing to use tinkerBOY’s DPI screen and AIO board. My question is will the Adafruit powerbooster supply enough amps to power a DPI screen, the AIO board and a Pi3 b+/a+?
Any input would be great.
Happy building!
Pi3 power requirements
Re: Pi3 power requirements
I dont think so. You are better off going with something like Helder's Retro PSU.
- infinitLoop
- Posts: 536
- Joined: Mon Dec 24, 2018 11:46 am
- Location: Portland, OR
- Has thanked: 222 times
- Been thanked: 199 times
- Contact:
Re: Pi3 power requirements
yeah, definitely not for all that. i think helder's psu is sold out until the new model comes out tho. tinkerboy's psu should also support that, but i think there are shipping delays currently for him too.
i've used this a couple times recently, but i can't vouch for how well it lasts under load. it is pretty inexpensive, which might be a bad sign, but it says it should do 2A, so it might support what you have listed: https://www.amazon.com/gp/product/B07PZT3ZW2
.
i've used this a couple times recently, but i can't vouch for how well it lasts under load. it is pretty inexpensive, which might be a bad sign, but it says it should do 2A, so it might support what you have listed: https://www.amazon.com/gp/product/B07PZT3ZW2
.
Some of my builds...
BMO GBZ
Star Wars Millenium Falcon Challenge
Game Boy Color Zero
... and another Gameboy Color Zero with custom 3D-printed parts
"Ultimate" 3A+ Build
GlowBoy Zero
Some 3d designs I've done...
Soft Tactile Shoulder Buttons, for screw-hole, well mounting
Snap-in, Soft Tactile Shoulder Button insert, for screw-hole, well mounting
Pac-Man and Space Invaders Themed Rear Fan Holder
BMO GBZ
Star Wars Millenium Falcon Challenge
Game Boy Color Zero
... and another Gameboy Color Zero with custom 3D-printed parts
"Ultimate" 3A+ Build
GlowBoy Zero
Some 3d designs I've done...
Soft Tactile Shoulder Buttons, for screw-hole, well mounting
Snap-in, Soft Tactile Shoulder Button insert, for screw-hole, well mounting
Pac-Man and Space Invaders Themed Rear Fan Holder
Who is online
Users browsing this forum: No registered users and 1 guest