Just finished my 1st GBZ project
Posted: Tue May 18, 2021 4:14 am
Hi folks, I'm just finished my first project. You guys builds were very helpful. Thx a lot!
I'm a guitar repairman, so there are many machine tools in the company. It was a lot of fun to process. *I usually enjoy repairing Vintage Macs.
Next up I have a 3.2 LCD project. However, when I tried to purchase a conversion board and LCD from Pocket Adventures, the seller did not accept any PayPal ID other than the PayPal ID made in the United States . I would like to contact John Till, but does anyone know the contact information?
http://www.pocketadventures.com/products.asp
My GBZ may not look particularly interesting, but I made it as clean as possible. Of course it is a no glue gun. I made it so that it can be disassembled for future failures.
GBZ is a genuine shell. The switch panel via 3.5LCD and GPIO is nothing strange, but the battery was 5000mhA. This was in a mobile battery I bought for about 5 USD. The noise filter is an application of high cut and high pass, and was made using two PCBs for SOT23. It was my first time even with a Raspberry Pi, but it was a great experience.I'm a guitar repairman, so there are many machine tools in the company. It was a lot of fun to process. *I usually enjoy repairing Vintage Macs.
Next up I have a 3.2 LCD project. However, when I tried to purchase a conversion board and LCD from Pocket Adventures, the seller did not accept any PayPal ID other than the PayPal ID made in the United States . I would like to contact John Till, but does anyone know the contact information?
http://www.pocketadventures.com/products.asp