Rob's GBZ WIP

[Robvp]

Finally gave myself some time to work on this.
Screen has been modified to work with 5v, this is the end result:


Soldered to the Pi:


After I soldered it to the Pi all I got was a white screen, solved it by soldering a ground cable into the pi tv input, figured it was just ground and wouldn't need it but apparently you do:




It's running off a 2800mah power amp

Up next, getting neo-geo to recognize my input and finally start cutting away the dmg case to fit the stuff.

[Robvp]

Btw, the case has been washed and treated with that hair dyeing thing, had a bottle of 30vol from when the GF used to dye her hair red and used that, results were acceptable

[vishald]

I am curious about the result of the red dye.

[Robvp]

I am curious about the result of the red dye.

Didn't use the red dye, just the developer I had laying around, it did clear up the yellow but not as much, not gonna mess with it any longer since I'm pretty sure I might mess up this case

[vishald]

Ah, i didn't read it well.
You gf used the dye for her red hair.

[Kilren]

I am curious about the result of the red dye.

Didn't use the red dye, just the developer I had laying around, it did clear up the yellow but not as much, not gonna mess with it any longer since I'm pretty sure I might mess up this case

Have you tried throwing it through a cycle in the dishwasher yet? Just turn off the heated drying (or pull it out before that).