Page 1 of 1
Watchmaker has started too
Posted: Sat May 14, 2016 5:31 pm
by the watchmaker
Finally got the three wing screwdriver. Still have a lot to do but
Retropie is running from rpi0
First buttons work
Got audio
Still waiting for a lot of parts. But I officially started.
Re: Watchmaker has started too
Posted: Sat May 14, 2016 5:47 pm
by Kilren
the watchmaker wrote:Finally got the three wing screwdriver. Still have a lot to do but
Retropie is running from rpi0
First buttons work
Got audio
Still waiting for a lot of parts. But I officially started.
I hate the three wing screws. As soon as I got them out, I switched to a standard phillip screw to never deal with that again.
Re: Watchmaker has started too
Posted: Sat May 14, 2016 10:30 pm
by crispy_tofu
@OP, can't wait!
re: tri-wing screws
I hear that you can remove triwing screws with a flathead screwdriver. I tried it once, took me a few hours of frustration. Never again - but its possible!
Re: Watchmaker has started too
Posted: Sun May 15, 2016 11:14 am
by davidn
What do you use to get audio?
Re: Watchmaker has started too
Posted: Sun May 15, 2016 5:51 pm
by Kilren
davidn wrote:What do you use to get audio?
Seems like there are a couple of main ideas here. The rpi0 does have audio out, which you can attach to an amp and so forth. The other is to install a usb hub (which you're hopefully doing anyway) and use usb audio. I personally am going to do the usb route because it is higher audio quality.