VeteranGamer wrote: ↑Tue Oct 31, 2017 7:05 amvnman wrote: ↑Tue Oct 31, 2017 3:14 amI need a bracket for this screen
Or some 3D printed screw bracket so that I can screw the two halves of the case together.
For anyone interested (it been done but no one posted it here) you can shave off 1 mm on the screen by carefully bend away the ribbon cable and cut off the white plastic part on the screen.
I do not have a dremel so I have to sand the two sides of the front half of the case by hand now the screen fits, just a little tight.
these might be of some help.....
HDMI ScrewBracket.stl
HDMI Button Wells.stl
place the screw bracket at the top and the button wells at the bottom, and the screen should slide in....
HDMI BWELLS with Analog.stl
this is a prototype, i havent used it so it may not be 100% (but its for anyone who wanted to add an analog stick)
hdmi gbz.stl
this is the one i used, but i have to modify it with a dremel to get everyting to fit right (where i placed the Pi Zero)
.
thanking you