Hi guys,
Currently mid-build for my Game Boy Zero and have run into audio issues...
I am using PAM8403 for my amp and have made a filter to try clean up the sound but the sound doesn't really change with the filter or without. This is the filter i am using https://learn.adafruit.com/assets/35685. I am using it in mono so have only built the top half.
For wiring i have RPI Physical Pin 12 to Filter, Filter to Amp L-IN, L-OUT to Speaker. The Amp is running to 5v supply from RPI. I have tried with and without a pot. The audio i get is a good volume but i have loads of interference whichever way i try to go. Am i just expecting too much? Any advice appreciated!
GBZ PWM Audio Filter Frustrations!
Re: GBZ PWM Audio Filter Frustrations!
Digital logic creates noise on the power supply rail. Take a look at the schematic of the Raspberry Pi 3 and you will see that they have a separate 3.3 V power supply for audio (3V3A) from their PMIC (MxL7704). They use an NC7WZ16 buffer to decouple the audio signal:
You can use an NC7WZ16 together with a low noise voltage regulator for this.
Additionally, use star grounding for your analog signals.
You can use an NC7WZ16 together with a low noise voltage regulator for this.
Additionally, use star grounding for your analog signals.
Who is online
Users browsing this forum: No registered users and 1 guest