Hello,
So I've been working on a custom pi0 build with usb-c and a custom case. The only issue is that I keep getting the "No controller recognized" screen, and when i try holding any button nothing seems to input. I've attached all my wiring. I have also already attempted to used a micro-b cable and use those wires and plug directly into the usb port on the pi, which didnt work. Finally I also tried to use my switch pro controller through the USB-c port and that also did not recognize. There is no continuity between D+ and D- according to my multimeter, and honestly Im out of ideas as to why this isnt working.
New Build won't detect any gamepad
- rodocop
- Posts: 1723
- Joined: Mon Aug 22, 2016 3:14 pm
- Location: Saskatchewan
- Has thanked: 606 times
- Been thanked: 608 times
Re: New Build won't detect any gamepad
Just to confirm, on the other side of the DPI board there should be two solder points for the data pads on the pi. I assume those are soldered?
_____________________________________________________
My Minty Pi builds:
http://www.sudomod.com/forum/viewtopic.php?f=32&t=3628
My GBZ builds:
http://www.sudomod.com/forum/viewtopic. ... 813#p50813
My modded DMG-01's:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2696
My NESpi:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2941
My Gaboze Pocaio's
https://sudomod.com/forum/viewtopic.php?f=13&t=6063
My Minty Pi builds:
http://www.sudomod.com/forum/viewtopic.php?f=32&t=3628
My GBZ builds:
http://www.sudomod.com/forum/viewtopic. ... 813#p50813
My modded DMG-01's:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2696
My NESpi:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2941
My Gaboze Pocaio's
https://sudomod.com/forum/viewtopic.php?f=13&t=6063
Who is online
Users browsing this forum: No registered users and 1 guest