sudomod

Hello everyone
I'm having some trouble figuring out how to wire my amp to my low-pass filter, my potentiometer and lastly my pi zero.
I do not have an AIO board and I'm running the audio in mono. I followed Wremy's original guide with the mono amp from Adafuit but I'm stuck now since I do not know where the wires are supposed to go. I am very new to all of this and all help is appreciated.
Thanks

Here's how I did mine. It shows the kitch bent low pass filter. Just replace that with your filter.

rodocop wrote: ↑

Sun Aug 06, 2017 7:41 am

audioShow

Here's how I did mine. It shows the kitch bent low pass filter. Just replace that with your filter.

Will this work with the radioshack pot wheel?

Probably. I'm not sure what the radio shack pot wheel is, or how it compares to mine (ebay). If it has 5 pins it's likely the same as my diagram.