Page 1 of 1
Been A While, But I'm Back With A New Inquiry
Posted: Wed Nov 08, 2017 12:48 pm
by NewBuilderMaker
SO.
Had too many issues the TFT screen, so I bought a back-up camera monitor. I've disassembled it and I seem to have one of the umpteen million variations of controller board.
Does anyone know how to convert this particular monitor from 12v to 5v? As always, any help is appreciated. Thanks, folks. Have a great day.
Re: Been A While, But I'm Back With A New Inquiry
Posted: Wed Nov 08, 2017 2:33 pm
by snoek09
Looks like an Innolux screen found on
http://www.sudomod.com/wiki/index.php?title=GBZ_Screen
It has this 5V mod picture:
Re: Been A While, But I'm Back With A New Inquiry
Posted: Thu Nov 09, 2017 11:53 am
by NewBuilderMaker
Oh dang, dude. Thank ya! I appreciate the assist.
Re: Been A While, But I'm Back With A New Inquiry
Posted: Sat Nov 11, 2017 1:05 pm
by Hex
NewBuilderMaker wrote: ↑Wed Nov 08, 2017 12:48 pm
SO.
Had too many issues the TFT screen, so I bought a back-up camera monitor. I've disassembled it and I seem to have one of the umpteen million variations of controller board.
Does anyone know how to convert this particular monitor from 12v to 5v? As always, any help is appreciated. Thanks, folks. Have a great day.
HEy I have the exact same screen. If you detach the pcb there is a place to solder 5v on the underside. Its very simple and clean.
Re: Been A While, But I'm Back With A New Inquiry
Posted: Sun Nov 12, 2017 9:33 am
by NewBuilderMaker
Hex wrote: ↑Sat Nov 11, 2017 1:05 pm
NewBuilderMaker wrote: ↑Wed Nov 08, 2017 12:48 pm
SO.
Had too many issues the TFT screen, so I bought a back-up camera monitor. I've disassembled it and I seem to have one of the umpteen million variations of controller board.
Does anyone know how to convert this particular monitor from 12v to 5v? As always, any help is appreciated. Thanks, folks. Have a great day.
HEy I have the exact same screen. If you detach the pcb there is a place to solder 5v on the underside. Its very simple and clean.
It seems they used some ridiculously hefty double sided tape so it refuses to budge. Still, if I can figure a safe way to do so I'll give that a whack.
Thank ya kindly.
Re: Been A While, But I'm Back With A New Inquiry
Posted: Sun Nov 12, 2017 11:26 am
by Hex
Try an xacto knife to separate the pcb from the screen. then it is easy to remove the tape