sudomod

Posted: **Mon Dec 25, 2017 7:31 am**

Hello everyone!

I have a problem with my button PCB. I soldered it straight to the Pi following this diagram:

SpoilerShow

: Figure-6_lightbox.png (148.54 KiB) Viewed 3429 times

but Retropie doesn't recognize anything, see pictures:

SpoilerShow

: IMG_4416.JPG (1.5 MiB) Viewed 3429 times

: IMG_5505.JPG (2.61 MiB) Viewed 3429 times

Can anyone help me solve this problem?

Thank you!!

Posted: **Mon Dec 25, 2017 8:09 am**

Retropie won't just recognize them right off the bat. You need to install retrogame. This is the guide I always folow, your gpio wiring is different but it shouldn't be too hard to adjust the code. Or just switch the wiring.

http://sudomod.com/forum/viewtopic.php?t=57

If you have done that and it still does not work. Let us know.

Posted: **Mon Dec 25, 2017 11:30 am**

Thank you for your reply, I'll get on it!

Posted: **Mon Dec 25, 2017 6:19 pm**

Check out the link on my signature. Much easier to setup this way.

sudomod

Problem with PCB

Problem with PCB

Re: Problem with PCB

Re: Problem with PCB

Re: Problem with PCB