trisfoz wrote: ↑Fri Mar 09, 2018 5:24 pmHi,stevetingate wrote: ↑Fri Mar 09, 2018 4:21 pmHey mate
thanks for the images
so did you wire anything to the power pads in the bottom left of the raspberry pi like in the image ?
or did you just go red, black to the gpio pins and and yellow to tv ?
No I did not wire anything to the 5V power pads. I just wired the red and black to the gpio pins (3.3V and GND) and and yellow to the tv composit pad.
just wanted to get it right!
and the red wire you ran from the vcc to the gpio pin ? did you just leave the other red wire unsoldered ? or unsolder it from the display board ?