Wiring PRS Tech Board SD-Cart Reader
Posted: Sat Mar 10, 2018 1:13 am
Hi all,
I have nearly finished my build and wanted to add some tweaks, like putting the SD-Card into the Cartridge.
Im using the PRS-Tech Board plus GBA Cartridge reader plus flat ribbon SD-Card extension.
I have wired everything that pin 1 from the SD-Reader from the pi matches Pin 1 in the Cartridge.
All lines have "beep" when testing but it doesnt boot up.
I realized PRS-Tech board only have 7 contacts used but the SD-Card has 8.
How I can check if there is a signal arriving at the pi?
I will try to shorten the lines also but I want to make sure that the wiring is correct.
Pin 6 from the SD-Card goes to Pin 15 from the Reader but there is no contact at the PRS-Board.
Connection from SD-Card to Cartreader is:
1->5
2->3
3->1
4->13
5->7
6->15
7->9
8->11
Im kinda lost.
Thanks for any help!
I have nearly finished my build and wanted to add some tweaks, like putting the SD-Card into the Cartridge.
Im using the PRS-Tech Board plus GBA Cartridge reader plus flat ribbon SD-Card extension.
I have wired everything that pin 1 from the SD-Reader from the pi matches Pin 1 in the Cartridge.
All lines have "beep" when testing but it doesnt boot up.
I realized PRS-Tech board only have 7 contacts used but the SD-Card has 8.
How I can check if there is a signal arriving at the pi?
I will try to shorten the lines also but I want to make sure that the wiring is correct.
Pin 6 from the SD-Card goes to Pin 15 from the Reader but there is no contact at the PRS-Board.
Connection from SD-Card to Cartreader is:
1->5
2->3
3->1
4->13
5->7
6->15
7->9
8->11
Im kinda lost.
Thanks for any help!