Page 1 of 1
Help getting board down to 5v
Posted: Sun Mar 25, 2018 5:05 pm
by Macromun
I recently got a screen for my GBZ project and it isn't a screen that isn't on the forum. This was a screen bought off Amazon, (
https://www.amazon.com/gp/product/B0045 ... UTF8&psc=1) and due to the nature of taking a product apart, I probably won't get a refund. If anyone could help me with this, it would be much appreciated!
Re: Help getting board down to 5v
Posted: Tue Mar 27, 2018 9:03 pm
by roxas232
Jump the power (red wire) to pin 3 on the AM569
http://www.datasheetlib.com/datasheet/1 ... #datasheet
It may work better if you remove the chip, not sure though
Re: Help getting board down to 5v
Posted: Wed Mar 28, 2018 1:51 pm
by Hex
Another safer and sure shot method is to use the 3.3v pin of the pi to 3.3v pin of the board for power supply. GND to GND and TV to AV1. That should work just fine
Re: Help getting board down to 5v
Posted: Mon Apr 09, 2018 6:41 am
by Keyn
I got this bw board and I don't know how I can make it to 5V.
I would be happy if somebody can help me
Re: Help getting board down to 5v
Posted: Mon Apr 09, 2018 8:12 am
by Thump52
Here you go, good luck with your build.
Re: Help getting board down to 5v
Posted: Mon Apr 09, 2018 8:29 am
by Keyn
Thank you
And you only have to connect the yellow or the white wire to the raspberry or?
Re: Help getting board down to 5v
Posted: Mon Apr 09, 2018 11:31 am
by Thump52
Yes only one, I personally just use the yellow wire.
Re: Help getting board down to 5v
Posted: Mon Apr 09, 2018 11:02 pm
by Keyn
Where did you got the screw bracket?