I gave it a try and the screen turns on, but it just displays lines. Keep in mind that this was basically my first time soldering, so it's really really bad and might even be the issue. I don't think I figured out how to keep the iron clean until I was about done. Also note that the white cable is not connected because I read somewhere else that it wasn't necessary. It's also a mistake that pp5 has solder on it (I accidentally made a bridge between that and 3.3v) but I'm pretty sure I separated them before I took these photos.
Anyway, I know it's a mess but if someone could put me in a direction, I'd really appreciate it.
For the connections:
Red to 3.3v
Black to ground
yellow to TV
white not connected
- IMG_20180411_043921[1].jpg (5.46 MiB) Viewed 5449 times
- IMG_20180411_044212[1].jpg (3.03 MiB) Viewed 5449 times
- IMG_20180411_044329[1].jpg (3.09 MiB) Viewed 5449 times