PSP 1000 joystick pins

Having trouble with your GBZ build? Ask your questions here!
Post Reply
J-Malice
Posts: 55
Joined: Fri Jun 02, 2017 2:40 pm
Has thanked: 33 times
Been thanked: 8 times

PSP 1000 joystick pins

Post by J-Malice » Sat May 19, 2018 2:41 pm

There is 4 pins to solder and there is an easy to find layout for them. The layout says:

VCC- UP/DOWN - GND - LEFT/RIGHT

The one on the wiki says to do White/Black/Red/Green for that order. But on Kites SAIO board the input list the cords as GND/Joy Y/3.3v/Joy X. Using the 4 wire JST that'd be Red/Green/White/Black. The GND and power still line up with that(white and red). So it'd power on fine. But if I am not mistaken it would flip the two directional inputs, if I follow these instructions(black and green). Am I correct and safe to flip it so they line up or is this particular mash up done for a reason? The only thing I can think of is that the software is programmed to accept the inputs this way and by changing it I will mess myself up.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest