What do I need to re-solder? SAIO

Having trouble with your GBZ build? Ask your questions here!
Post Reply
User avatar
WoodMill
Posts: 181
Joined: Tue Sep 06, 2016 11:57 am
Location: Indianapolis, Indiana, USA
Has thanked: 21 times
Been thanked: 29 times

What do I need to re-solder? SAIO

Post by WoodMill » Fri Jun 08, 2018 11:41 am

I'm finally getting around to building my Kite SAIO, and am running into a testing issue. I've finally worked the two USB pads on the Zero to finally make a connection, but am confused as to why the USB Audio and Hub work, but not the Arduino or Joystick. What pads control them? I'm working off of Kite's build on gethub here: https://github.com/kiteretro/Super-AIO/ ... SAIO-v0.6c

What do I need to look at?
2018-06-08 13.29.19.jpg
2018-06-08 13.29.19.jpg (2.62 MiB) Viewed 1752 times
Follow my Youtube Vlog about Filmmaking
https://www.youtube.com/playlist?list=P ... P0H6UZe1ds

User avatar
WoodMill
Posts: 181
Joined: Tue Sep 06, 2016 11:57 am
Location: Indianapolis, Indiana, USA
Has thanked: 21 times
Been thanked: 29 times

Re: What do I need to re-solder? SAIO

Post by WoodMill » Fri Jun 08, 2018 12:30 pm

What a pain, but I figured it out. One of the surface mount chips wasn't properly soldered. I was inspecting the Arduino area of the board, and noticed that there may have been a lead not properly soldered. I couldn't get a real good look at it since its so small. So I added some solder to it, and boom, Arduino and Joystick show up as OK now.

Now my question is, what's the GPIO SHDN? Mine still says off, but in Kite's example, it shows ON.
solder.jpg
solder.jpg (949.26 KiB) Viewed 1742 times
Follow my Youtube Vlog about Filmmaking
https://www.youtube.com/playlist?list=P ... P0H6UZe1ds

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest