No Output with Screen Variant 9

spacemishka · Post by **spacemishka** » Fri Jun 29, 2018 3:37 pm

Hello,

i wired up my rasperry zero with a composite screen (variant 9). But it doesnt show anything.

in config.txt i changed:

#hdmi_force_hotplug=1
sdtv_mode=2

any ideas?

Peter

GunZi · Post by **GunZi** » Sat Jun 30, 2018 8:55 am

https://www.sudomod.com/wiki/index.php/ ... t-9_5V.jpg

1) remove the chip completely

2) you have soldered to the wrong pin, see pic in link above, solder to the pad below the one you have soldered to.

spacemishka · Post by **spacemishka** » Sat Jun 30, 2018 11:42 am

Last discussion about the Chip was ending up with keeping it in Place. But yes i did solder it wrong