I find these projects fun, but unfortunately I have no natural intuition for them. I'm working on my 2nd build (my 1st one was a total disaster), and I need some help. I'm using the tinkerBoy 2.0 controller and the Powerboost 1000c, and I'm stuck on a couple of points:
1. Where do I connect the wires for the the on/off switch to the Powerboost? The through holes I've seen on other diagrams/videos are used in other ways with the tinkerBoy board?
2. Where do I connect the wires for the micro USB charging port in this setup? The tinkerBoy or the Powerboost?
Any help would be greatly appreciated!
Stuck on wiring GBZ (tinkerBoy v2.0 board)
Re: Stuck on wiring GBZ (tinkerBoy v2.0 board)
Thank you so much! I’ll try it tomorrow, and post here about how it went.
Who is online
Users browsing this forum: No registered users and 1 guest