I've worked on small electronics projects before so I'm still new to this. I've recently started a GBZ build by modifying the case and it's gone pretty well; I consider this to be my first big DIY electronic project. I bought a Leonardo Pro Micro ATmega32U4 5V/16MHz and a PRS Tech button board but have no idea how I would wire them together. Can someone show me a diagram of how to wire them?
Thanks for any help!
(GBZ) Lenardo Pro Micro and PRS Tech Button Board
- iNEEDZPANCAKES
- Posts: 1
- Joined: Thu Oct 11, 2018 8:07 pm
- Has thanked: 1 time
- VeteranGamer
- Posts: 1738
- Joined: Thu Jan 26, 2017 11:12 am
- Location: London, UK
- Has thanked: 528 times
- Been thanked: 909 times
Re: (GBZ) Lenardo Pro Micro and PRS Tech Button Board
Follow Tinkerboy guide on how to program the Pro Micro....
http://www.tinkerboy.xyz/how-to-program ... h-arduino/
And the just wire up how you see fit....
The points on the Pro Micro (except analog/power) are all buttons, it doesn’t matter where they go on your button PCB....
You’ll assign them in the controller setup at the startup in emulation station...
.
http://www.tinkerboy.xyz/how-to-program ... h-arduino/
And the just wire up how you see fit....
The points on the Pro Micro (except analog/power) are all buttons, it doesn’t matter where they go on your button PCB....
You’ll assign them in the controller setup at the startup in emulation station...
.
Who is online
Users browsing this forum: No registered users and 1 guest