sudomod

I've worked on small electronics projects before so I'm still new to this. I've recently started a GBZ build by modifying the case and it's gone pretty well; I consider this to be my first big DIY electronic project. I bought a Leonardo Pro Micro ATmega32U4 5V/16MHz and a PRS Tech button board but have no idea how I would wire them together. Can someone show me a diagram of how to wire them?

Thanks for any help!

Follow Tinkerboy guide on how to program the Pro Micro....
http://www.tinkerboy.xyz/how-to-program ... h-arduino/


And the just wire up how you see fit....
The points on the Pro Micro (except analog/power) are all buttons, it doesn’t matter where they go on your button PCB....

You’ll assign them in the controller setup at the startup in emulation station...



.