PRS-Tech Giveaway

[prerunnerseth]

And the Winner is! Joe LaTendresse!!!!

[Holydohnut]

Ah, dangit! Oh well! Congratulations Joe! I have now completed my build of the board I received which for the most part went really easily. Few points though.

1. I bought a REALLY cheap controller to gut. (£3 from Amazon) this controller must have the L and R buttons at a different angle as the PRS board covered up where the L and R pcb's slotted in. However it only took a quick dremeling to both the PRS pcb and the L and R pcb's to get it to fit.

20170522_161558.jpg (3.3 MiB) Viewed 4344 times

2. I gave up on the nicely fitting hdmi cables to come back into stock, and just ordered a different type, with the intention of making the cable hole wide enough to have the cable always fitted. It's not quite as pretty, but it does the job!

20170530_195621.jpg (3.53 MiB) Viewed 4344 times

All in all this was an awesome project. I plan to add the power button as detailed a few steps up, and don't be surprised if I order a few more boards for friends and family! I reckon the total cost of this was sub £30 so it falls nicely in the bracket of Christmas Presents!

Cheers

Rik

[megamax510]

Tomorrow is the big day.... Can't wait to give this thing away!

have another kit?