[SOLD OUT] DIY Safe Shutdown v1.0 (for PowerBoost)

[Ryota]

thanks a lot. I ordered one!

[Maylot]

Thanks, just ordered one

[Eccho]

Ordered one as well!

[larsen2011]

Ordered two...

I really hoped that @Camble would release the wiring diagram to build this circuit on my own, but I have to say this is a great deal and with the switch (and of course everything else) not installed, I might be able to place the PCB somewhere else to keep the room.

[Eccho]

The only thing that may trip people up is getting the transistors mixed up, but everything is marked and only goes in one place.

I might challenge your fool-proof setup

Just from the photo of the finished product you posted, the colors indicate that there are 5 different resistors for a total of 6.
So from left to right, we have the small red resistor followed by 5 teal ones. Among the teal resistors, do you confirm that teal resistor number 2 and 3 are identical?

Thanks for all your work.

[Camble]

The only thing that may trip people up is getting the transistors mixed up, but everything is marked and only goes in one place.

I might challenge your fool-proof setup

Just from the photo of the finished product you posted, the colors indicate that there are 5 different resistors for a total of 6.
So from left to right, we have the small red resistor followed by 5 teal ones. Among the teal resistors, do you confirm that teal resistor number 2 and 3 are identical?

Thanks for all your work.

That's correct. Although, the red one is a diode and must be soldered the correct way round.

[umbynos95]

Ordered two! Thanks! What are the differences from v1.2?

[VitaliBR]

Unfortunately sending to my country will be expensive and time consuming (Brazil) Would it be possible for me to pay for the PCB and you send the schematic by e-mail?
That way I mount my PCB and you do not need to send a PCB to me.

Thanks

[144TECH]

lol

[scbailey94]

@camble Have these been posted out yet? I wasn't sure if you were waiting until you reach a certain amount of orders or something before you send them out