Circuit gem select and start button!

Post Reply
Darth Mika
Posts: 5
Joined: Wed Nov 09, 2016 8:45 am
Has thanked: 2 times

Circuit gem select and start button!

Post by Darth Mika » Mon Jul 15, 2019 6:10 am

Some have put L / R buttons on the Circuit gem. I thought if I could fit it, then I could also put a select and start button on it. Is it possible ... in your circuit gem program? :roll:

User avatar
kite
Posts: 886
Joined: Thu May 12, 2016 4:30 am
Location: UK
Has thanked: 229 times
Been thanked: 299 times
Contact:

Re: Circuit gem select and start button!

Post by kite » Tue Jul 16, 2019 5:04 am

i don't think there are any extra pins free, there may be 1x.. but the extra "L" and "R" ones are the only ones. With the power switch mode menu, you can toggle the START/SELECT buttons between X/Y mode, if that helps

Darth Mika
Posts: 5
Joined: Wed Nov 09, 2016 8:45 am
Has thanked: 2 times

Re: Circuit gem select and start button!

Post by Darth Mika » Tue Jul 16, 2019 3:05 pm

kite wrote:
Tue Jul 16, 2019 5:04 am
i don't think there are any extra pins free, there may be 1x.. but the extra "L" and "R" ones are the only ones. With the power switch mode menu, you can toggle the START/SELECT buttons between X/Y mode, if that helps
Okay! Good to know!
Add at least those L / R keys.
I thought I would change the d-pad, mode, sleep, a, b buttons better.

That's an alternative d-pad
https://cdn-shop.adafruit.com/datasheet ... 0-ALPS.pdf

The battery and the processor make the VMU a bit hot ... I thought to put the fan behind if it fits.

https://www.sepa-europe.com/en/news/new-sepa-micro-fans

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest