Hey,
I recently build my circuit sword and short before assabmling everything the powerswitch suddenly stopped working.
Mode button works, back buttons (L and R) also work.
I can turn on the sword with the button on the pcb but not with the switch.
greetings shake
Power switch won't turn circuit sword on
-
- Posts: 17
- Joined: Sat Mar 02, 2019 12:22 pm
- Location: Portland, OR, USA
- Has thanked: 6 times
- Been thanked: 6 times
- Contact:
Re: Power switch won't turn circuit sword on
Interestingly, I’ve just run into this problem as well. I’ve built a number of these boards before and I have three right now. I’ve tested two different boards on the bench and both are having this problem.
Re: Power switch won't turn circuit sword on
Interesting. Especially because mine stopped literally overnight.
Any conclusions already? I might change the ribbon cable.
Pretty clueless right now.
Any conclusions already? I might change the ribbon cable.
Pretty clueless right now.
-
- Posts: 17
- Joined: Sat Mar 02, 2019 12:22 pm
- Location: Portland, OR, USA
- Has thanked: 6 times
- Been thanked: 6 times
- Contact:
Re: Power switch won't turn circuit sword on
Following up on this, I’ve tested all four (turns out I bought four, not three) Circuit Shields (v1.3D 20190205) and none of them will power on with the switch through the accessory board. The accessory board is V1.1C.
When I press the power button on the main board I see the 5v PWR status light on the accessory board turn on, so power is at least making it back up to the accessory board.
I sent a couple emails off to Kite, but no word yet. I’m not exactly sure where to begin diagnostic tracing, but this is the first time I’ve ever run into a problem with one of these boards.
When I press the power button on the main board I see the 5v PWR status light on the accessory board turn on, so power is at least making it back up to the accessory board.
I sent a couple emails off to Kite, but no word yet. I’m not exactly sure where to begin diagnostic tracing, but this is the first time I’ve ever run into a problem with one of these boards.
Re: Power switch won't turn circuit sword on
Hey,
Sry for the late reply!
Thanks for sharing. At my current state I have absolutely no idea where to start as well! Could you respond if you get an update from kite?
Greetings
Sry for the late reply!
Thanks for sharing. At my current state I have absolutely no idea where to start as well! Could you respond if you get an update from kite?
Greetings
Who is online
Users browsing this forum: No registered users and 1 guest