sudomod

My build has stopped booting. When i plug in the board, it gets power and the LEDs all light up, but nothing happens on the screen. I enabled wifi via adding a wpa_supplicant.conf file to the boot section of the sd card. The board never connects to my wifi, any way to confirm this is the issue.

Thanks so much guys!

Are you using the 320x or 640x version of the screen?

If you have the 640x version, check:
https://github.com/kiteretro/Circuit-Sw ... 40x480-lcd

Well, i was using my 640x screen, but i swapped it out to the stock 320 screen (after undoing the config.txt steps to enable it) and it boots, so i may have a bad screen.