Started getting my Circuit Shield together today, Ran through the set up here:
https://github.com/kiteretro/Circuit-Sh ... uit-Shield
Everything seems fine till step 11, where i don't get anything on my display, just white display (see Image 1).
Searching the forums it the only similar issues have either been with a badly seated CM3 or with solder on the SODIMM slot pins, neither seem to be my issue.(see image 3 and 5)
If I turn the device ON then OFF shortly after it stays on, but if i wait long enough before turning the device OFF it will turn off, would that mean its booting up enough to run the safe shutdown and that the screen is the issue? Im guessing not as it does seem to turn of immediately when it gets to that point.
The lights also change after being on for about 30 seconds(ACT becomes solid and FAN stops lighting up) See Image 2
Any suggestions on what i could do to work out what's wrong?