I have the original version of Kites SAIO board v0.5 and after FINALLY putting the thing together I didn't read the fine print on HoolyHoos bracket and didn't trim the screws. I ended up with a big digital artifact where I drove the screw too far into the screen trying to tighten my perfect finished case.
Sigh.
So where can I get a replacement screen for that model? I do have an OLDER Gearbest screen I was using for a different build, found at the bottom of this page. (https://www.sudomod.com/wiki/index.php?title=GBZ_Screen) I haven't compared the ribbons but in my mind they sure look similar. Is that an option, and if not, will Kite please sell me another screen. I'm so bummed that I was fastidious up until literally the last step of the build and then I busted it.
Please help.
Jerm
Cracked Screen
-
- Posts: 23
- Joined: Fri Jun 17, 2016 6:16 pm
- Has thanked: 22 times
- Been thanked: 4 times
- kite
- Posts: 972
- Joined: Thu May 12, 2016 4:30 am
- Location: UK
- Has thanked: 246 times
- Been thanked: 361 times
- Contact:
Re: Cracked Screen
Search for "LQ035NC111" and you'll find it
Most of those 3.5" screens are the same, if it is a 54Pin connector, it'll work (as there are no other LCDs with 54P connector)
Most of those 3.5" screens are the same, if it is a 54Pin connector, it'll work (as there are no other LCDs with 54P connector)
Stock clearance - CLOSED: viewtopic.php?f=38&t=12064
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
Who is online
Users browsing this forum: No registered users and 1 guest