Hey there,
i have a new issue with my Kite circuit sword.
I just soldered a new mode switch on (the ones that are recommended in the wiki (https://github.com/kiteretro/Circuit-Sw ... own-Issues))
but now it is registering as a constant pushed in state.
as far as i know my soldering iron was not to hot either (230 Celsius) so i hope i did not burn any lines
There is a little hole near the mode button that got some solder in accidentally, but that would seem very odd that could be the problem
[Kite's Circuit Sword] Mode button constantly registered as pressed.
Re: [Kite's Circuit Sword] Mode button constantly registered as pressed.
i might have found the problem,
seems like its a faulty mode button. a little bend and it works like supposed.
i'll report back when i know for sure.
seems like its a faulty mode button. a little bend and it works like supposed.
i'll report back when i know for sure.
-
- Posts: 9
- Joined: Wed Feb 21, 2018 9:46 pm
- Has thanked: 3 times
- Been thanked: 3 times
Re: [Kite's Circuit Sword] Mode button constantly registered as pressed.
If it happens while the case is closed, check to make sure it's not shorting out on the USB-C port. I had to put kapton tape on mine.
Re: [Kite's Circuit Sword] Mode button constantly registered as pressed.
Did you ever find the solution? I've having the same issue.
Who is online
Users browsing this forum: No registered users and 1 guest